安科瑞防逆流電表在菲律賓光伏項目的應用

時間：2021-10-28作者：江蘇安科瑞電器制造有限公司瀏覽：5

1.項目背景Background

??隨著光伏行業的發展，部分地區村級變壓器及工業用電變壓器容量與光伏項目的裝機容量處于飽和。電網公司要求對后建的光伏并網系統為不可逆流發電系統，指光伏并網系統所發生的電由本地負載消耗，多余的電不允許通過低壓配電變壓器向上級電網逆向送電。

??With the development of photovoltaic industry, the capacity of village-level transformers and industrial power transformers and the installed capacity of photovoltaic projects are saturated in some areas.The power grid company requires the photovoltaic grid-connected system to be a non-backflow current generation system, which means that the electricity generated by the photovoltaic grid-connected system is consumed by the local load, and the excess electricity is not allowed to be sent to the upper power grid through the low-voltage distribution transformer in reverse direction.

??光伏逆變器在將光伏組件產生的直流電變換為交流電時，會夾雜有直流分量和諧波，三相電流不平衡，輸出功率不確定性等，目前基本沒有采取治理手段，因此，當有發電功率送往公用電網時，就會對電網產生諧波污染，易造成電網電壓波動，閃變等，如果有許多這樣的發電源向電網輸電時，會導致電網電能質量嚴重下降。所以這類光伏發電系統須配套加裝防逆流設施，來防止逆功率的發生。

??Photovoltaic inverter in photovoltaic components will produce direct current into alternating current (ac), has the dc component and harmonic mixing, unbalanced three phase current, output power of uncertainty, such as the current basic didn't take effective management measures, therefore, when there is power to the utility grid, will generate harmonic pollution to power network, easy cause power grid voltage fluctuation and flicker, etc.,If there are many such power sources to transmit electricity to the grid, the power quality of the grid will be seriously degraded.Therefore, this kind of photovoltaic power generation system must be equipped with anti-backflow current facilities to prevent the occurrence of reverse power.

??當光伏發電量大于負載需求電量時，會產生逆功率。因此，我們需要儀表來判定。逆變器有過功率輸出，再由儀表通過RS485通訊發出信號和逆變器數據交互，調節逆變器輸出功率，使其輸出功率和用電功率平衡。

??When the photovoltaic power generation is greater than the load demand, the inverse power will be generated.So we need instruments to determine that Inverter has power output, and then by the instrument through RS485 communication ** and inverter data interaction, adjust the inverter output power, so that its output power and power balance.

2.項目概述Project Overview

??菲律賓一家做光伏發電的公司，聯系到我司，尋找防逆流電表  ， 對接協議合適后， 采購我司的ACR10R-D16TE.

??A photovoltaic power generation company in the Philippines contacted our company to look for anti-backflow current meters. After proper connection agreement, we will purchase ACR10R-D16TE from our company.

3.防逆流檢測儀表Anti-backflow detection meter


??當光伏發電量大于負載需求電量時，會產生逆功率。因此，我們需要儀表來判定逆變器有過功率輸出，再由儀表通過RS485通訊發出信號和逆變器數據交互，調節逆變器輸出功率，使其輸出功率和用電功率平衡。

??When the photovoltaic power generation is greater than the load demand, reverse power will be generated. Therefore, we need an meter to determine that the inverter has over-power output, and then the meter sends a ** through RS485 communication to interact with the inverter data to adjust the output power of the inverter to balance the output power and the electrical power.


江蘇安科瑞電器制造有限公司專注于一體式電動機保護器,馬達保護器廠家等

• 詞條

  詞條說明

• 馬達保護器的工作原理

  馬達保護器的工作原理馬達保bai護器的工作原理是；傳感器將電動機du的電流變化線性地反映至保zhi護器的采樣端口，經過整流dao、濾波等環節后，轉換成與電動機電流成正比的直流電壓信號、送到相應部分與給定的保護參數進行比較處理，再經單片機回路處理，推動功率回路，使繼電器動作。當電機由于驅動部分過載導致電流增大時，從電流傳感器**的電壓信號將增大、此電壓值大于保護器的整定值時，過載回路工作，RC延時電

• 什么是馬達保護器里面的保護模式啟動

  什么是馬達保護器里面的保護模式啟動馬達保護器（又名電動bai機保護器）的作用是給電動du機全面的保zhi護，在電動機出現**時啟dao動、過流、欠流、斷相、堵轉、短路、過壓、欠壓、漏電（接地）、三相不平衡、過熱、軸承磨損、定轉子偏心、外部故障、來電自啟動、反時**，予以報警或保護的裝置。

• 關于有源濾波器的工作原理介紹

  一、研究諧波的意義(1)諧波的危害十分嚴重。諧波使電能的生產、傳輸和利用的效率降低;使電氣設備過熱,產生振動和噪聲,并使絕緣老化,使用壽命縮短,甚至發生故障或燒毀。(2)諧波可引起電力系統局部并聯諧振和串聯諧振,使電能計量出現混亂。對于電力系統外部,諧波對通信設備和電子設備會產生嚴重干擾。二、抑制諧波基本思路(1)裝設諧波補償裝置來補償諧波裝設諧波補償裝置的傳統方法是采用LC調諧濾波器。這種方法既

• 安科瑞防逆流電表在菲律賓光伏項目的應用

  1.項目背景Background 隨著光伏行業的發展，部分地區村級變壓器及工業用電變壓器容量與光伏項目的裝機容量處于飽和。電網公司要求對后建的光伏并網系統為不可逆流發電系統，指光伏并網系統所發生的電由本地負載消耗，多余的電不允許通過低壓配電變壓器向上級電網逆向送電。 With the development of photovoltaic industry, the capacity of vil